Set up your sign
Three steps and a couple of minutes, all from your phone. No app or account needed.
-
Plug it in
Use the power supply in the box. Within a minute the sign says SETUP / JOIN WIFI / SIGNALBOX.
-
Connect it to your Wi-Fi
On your phone, open Wi-Fi settings and join the network called SignalBox. A setup page opens by itself. If it doesn't, type
http://192.168.4.1into your browser.Choose your home Wi-Fi and type its password. The sign shows CONNECTED and its address for 3 minutes, then the trains appear.
-
Choose your station
Put your phone back on your home Wi-Fi and open
signalbox.localin its browser. If that doesn't open, type the address the sign showed under CONNECTED.Pick your station for the arrivals board, and set the clock, brightness and night hours.
Bookmark that page: it's where all the settings live.
Hanging it
Three keyholes on the back drop onto a nail or screw. One is enough; use two or three for a sign that stays straight. It also stands on a shelf.
Reading the sign
- Each light on a track is a train; its fading tail shows which way it's going. The map updates every 15 seconds.
- A dim train means its live data is a few minutes old. If every train is dim, the sign can't reach the live data right now. It recovers by itself.
- The board lists the next trains at your station, in minutes. A time like 4:28 is the next scheduled train, shown when nothing is due soon.
- The sign goes dark overnight and while no trains run, and comes back on its own.
- Updates install by themselves overnight. Nothing to do.
If something's not right
There's no SignalBox network
The sign only offers it when it can't join a saved Wi-Fi network. Unplug it for 10 seconds and plug it back in, then wait about a minute.
My Wi-Fi isn't in the list
The sign needs a 2.4 GHz network. Most routers have one, often under the same name as their 5 GHz network. Networks with a sign-in page, like many work, school and apartment-building networks, won't work.
The settings page won't load
Make sure your phone is on the same Wi-Fi as the sign, not a guest network. If signalbox.local doesn't open, use the number address the sign showed under CONNECTED.
I changed my Wi-Fi or got a new router
Unplug the sign and plug it back in. About a minute later it offers the SignalBox network again: repeat step 2.
All the trains are dim
The sign can't reach the live data. Usually it's your internet or a short outage on our side, and it clears up by itself. If it lasts more than an hour, email us.
The front came loose
It's held on by pegs and small magnets. Line it up and press it back on.
Still stuck? Just ask.
Email and you'll hear back from the person who built your sign, usually within a day.